Modular Sukkah Hardware

1. PANEL TO PANEL ASSEMBLY NOTE: ALL PANELS AND CORNER SECTIONS WORK ON A "MALE/FEMALE" ASSEMBLY SYSTEM AND MUST BE INSTALLED FROM THE INSIDE ONLY. You cannot use two "male" or "female sides to mate panels, or corner sections, because they will not lock together. NOTE: If your sukkah has a window, or picture panel(s), start assembly - with the "male" edge to the left of the inside face. Position panel at a 45° angle then insert side of Panel 1 into "female" side of Panel 2, as shown in the diagram. Swing panels into place. (SEE ARROW) All support bars should be facing the outside The door panel is the same size as the wall panels and me be substituted for any wall panel throughout your sukkah. If panels don't match up, turn one panel upside down. (There is no top or bottom to panels.)

NOTE: Don't leave window, painted panels, or silk screen panels for last, since they cannot be turned upside down.

2. PANEL LOCK INSTALLATION After each panel to panel connection is made, slide lock over outside flange of panels to secure the panels in place. (SEE DIAGRAM). The lock should be slid down to the panels first horizontal support rib. To double secure both panels a 12" long bar with a cut in the middle is placed on top and bottom of panels.

NOTE: The lock is used to lock the panels together and is not used in the corners or door panel.

3. CORNER ASSEMBLY Hook "female" side of corner section into "male" side of panel, then swing in the direction of arrow shown in diagram. NOTE: The next panel is assembled to the "male" side of the corner in a similar fashion (or visa versa).

CONTINUED >